Дырокол пасечный универсальный

Дырокол пасечный универсальный
Price: 0.00 грн.
Qty:     - OR -   Add to Wish List Add to Compare
The puncher puncher with the installation of the sleeves is designed for punching holes and installing the sleeves (with the inner diameter of the sleeve no more than Ø1.8 mm) at the same time. It is used for frames like "Dadan", "Ruth" and "Poluramka". A distinctive feature of this punch model is that it is possible to perform hole punching and installation of bushings in one operation. Before starting work, lift the handle (pos. 3) upwards and install the bushings on the needles (pos. 2), then set the frame or a separate bar, as shown in the figure (Fig. 1), adjusting the screws (pos. 5) so that, after punching, the holes were parallel to the end of the bar. Press the hole punch handle and lift it back. In case the sleeve remains on the needle, repeat the punching operation again. If the holes will be punched not on the frame assembly, but only on the bar, then an adjusting stop (pos. 4) must be set. When using the punch, it is recommended to fix it on the table surface; for this purpose, fixing grooves are made at the base (position 1).